Self Aligning Ball Bearings
This type of ball bearing is recommended when alignment of the shaft and housing is difficult and the shaft may flex. The outer ring has a spherical raceway and its center of curvature coincides with that of the bearing; therefore, the axis of the inner ring, balls and cage can deflect to some extent around the bearing center. Pressed steel cages are usually used. Since the contact angle is small, the axial load capacity is low. The permissible dynamic misalignment is approximately 0.07 to 0.12 radian (4 to 7 degrees) under normal loads.
However, depending on the surrounding structure, such an angle may not be possible.
- CONSOLIDATED BEARING 2222 C/3 Self Aligning Ball Bearings
- Cast Iron
- #4 Radial Extra Thrust
- CONSOLIDATED BEARING 2322-K Self Aligning Ball Bearings
- Normal Duty
- Setscrew Ball Bearing
- CONSOLIDATED BEARING 2322 M Self Aligning Ball Bearings
- Normal Duty
- Setscrew Ball Bearing
- CONSOLIDATED BEARING 2322 Self Aligning Ball Bearings
- Normal Duty
- Setscrew Ball Bearing
- CONSOLIDATED BEARING RM-9 Self Aligning Ball Bearings
- Intermediate Duty
- Setscrew Ball Bearing
- CONSOLIDATED BEARING RM-8 Self Aligning Ball Bearings
- Normal Duty
- D-Lock Ball Bearing
- CONSOLIDATED BEARING RM-7 Self Aligning Ball Bearings
- Normal Duty
- Setscrew Ball Bearing
- CONSOLIDATED BEARING RM-6 Self Aligning Ball Bearings
- Normal Duty
- Setscrew Ball Bearing
- CONSOLIDATED BEARING RM-22 Self Aligning Ball Bearings
- Normal Duty
- Setscrew Ball Bearing
- CONSOLIDATED BEARING RM-26 Self Aligning Ball Bearings
- Normal Duty
- Setscrew Ball Bearing
- CONSOLIDATED BEARING RM-14 Self Aligning Ball Bearings
- Normal Duty
- Setscrew Ball Bearing
- CONSOLIDATED BEARING 2319-KM Self Aligning Ball Bearings
- Intermediate Duty
- Setscrew Ball Bearing